6年前 このリリース以降 7 件のコミットが master へ反映されました。
The first PCB release considered stable! Very similar to v0.3, this release is optimized for lower cost while retaining all functionality of the previous release.
Due to the last point, the programming jig did not require any changes in this release.
6年前 このリリース以降 25 件のコミットが master へ反映されました。
A PD Buddy Sink designed for automated assembly!
Additionally, a programming jig has been designed to accommodate programming the Sink without a boot switch or programming header installed. The PCB can be found in the programming-jig
directory, and a 3D-printed spacer can be found in the pd-buddy-openscad repository.
7年前 このリリース以降 54 件のコミットが master へ反映されました。
Finally, a hand-solderable Sink that doesn’t need rework! The output circuit has been fixed, so no cutting traces and point-to-point wiring should be necessary.
Other changes:
All the schematic changes have already been tested, so v0.2 should be ready for use. However, this is considered a pre-release because it isn’t really meant to be sent to a PCBA house yet.
7年前 このリリース以降 81 件のコミットが master へ反映されました。
Initial prototype of PD Buddy. There are some pretty serious bugs here, so please don’t spend money to bring more of this version into the world. You’d be much better off using a newer version if you want to make a PD Buddy Sink.