PD Buddy Sink schematics and circuit board

Clara Hobbs be13c95997 Moved board edge 0.5 mm closer to P1 The USB Type-C connector was a bit far from the board edge, so I moved the edge 0.5 mm closer to it. This allows enclosure walls to be thicker and whatnot. I also moved the screw holes back to keep them the same distance from the board edge, and moved D4 and R10 to keep their text unobscured.		7 年前
pd-buddy.pretty	Added PD-Buddy v0.1 PCB	7 年前
.gitignore	Initial commit	7 年前
LICENSE	Added license (CERN OHL 1.2)	7 年前
README.md	Initial commit	7 年前
fp-lib-table	Added PD-Buddy v0.1 PCB	7 年前
microcontroller.sch	Corrected type of INT_N sheet pin	7 年前
output.sch	Added a jumper to make SW1 optional	7 年前
pd-buddy-cache.lib	Corrected BJT connections	7 年前
pd-buddy.csv	Added PD-Buddy v0.1 PCB	7 年前
pd-buddy.dcm	Corrected BJT connections	7 年前
pd-buddy.kicad_pcb	Moved board edge 0.5 mm closer to P1	7 年前
pd-buddy.lib	Corrected BJT connections	7 年前
pd-buddy.pro	Added PD-Buddy v0.1 PCB	7 年前
pd-buddy.sch	Corrected type of INT_N sheet pin	7 年前
pd_phy.sch	Added a jumper to make SW1 optional	7 年前
usb_type-c.sch	Added a jumper to make SW1 optional	7 年前
voltage_regulator.sch	Corrected MOSFET connections	7 年前

pd-buddy-pcb

PD-Buddy circuit board