pd-buddy/pd-buddy-firmware: PD Buddy Sink Firmware

PD Buddy Sink Firmware

履歴

Clara Hobbs 9ee738b04c Only set the output in trans.sink when not min pwr When we receive a GotoMin message, we immediately go to lower power before entering the PE_SRC_Transition_Sink state. Therefore, the call to pdb_dpm_output_set was redundant in this case. Now the call isn't made in this case, removing the redundancy. This also leads somewhat into the design of the new library.		6年前
..
config.c	Rename storage.? -> config.?	6年前
config.h	Rename storage.? -> config.?	6年前
device_policy_manager.c	Rename storage.? -> config.?	6年前
device_policy_manager.h	Read the Type-C Current in the PE, not the DPM	6年前
fusb302b.c	Add macros for FUSB302B TX FIFO tokens	6年前
fusb302b.h	Added FUSB302Bxx I2C address macros	6年前
hard_reset.c	Wrote a mostly-complete USB PD 2.0 implementation	7年前
hard_reset.h	Wrote a mostly-complete USB PD 2.0 implementation	7年前
int_n.c	Added over-temperature protection	7年前
int_n.h	Wrote a mostly-complete USB PD 2.0 implementation	7年前
led.c	Added "identify" command	7年前
led.h	Use semantic LED event names	7年前
main.c	Added output command	6年前
messages.c	Wrote a mostly-complete USB PD 2.0 implementation	7年前
messages.h	Wrote a mostly-complete USB PD 2.0 implementation	7年前
pd.h	Improved error handling for set_v and set_i	7年前
policy_engine.c	Only set the output in trans.sink when not min pwr	6年前
policy_engine.h	Request new power without sending Get_Source_Cap	6年前
priorities.h	Wrote a mostly-complete USB PD 2.0 implementation	7年前
protocol_rx.c	Wrote a mostly-complete USB PD 2.0 implementation	7年前
protocol_rx.h	Wrote a mostly-complete USB PD 2.0 implementation	7年前
protocol_tx.c	Wrote a mostly-complete USB PD 2.0 implementation	7年前
protocol_tx.h	Wrote a mostly-complete USB PD 2.0 implementation	7年前
shell.c	Rename storage.? -> config.?	6年前
shell.h	Added a command shell and storage functions	7年前
usbcfg.c	Add support for the firmware version extension	6年前
usbcfg.h	Added a command shell and storage functions	7年前