PD Buddy Sink schematics and circuit board

Clara Hobbs 23a8743994 Moved SW1 slider over board The slider for the Boot switch is no longer overhanging the board edge. This is nice for designing enclosures, as now nothing overhangs the long sides of the board.		7年前
pd-buddy.pretty	Added pasteless footprints	7年前
.gitignore	Initial commit	7年前
LICENSE	Added license (CERN OHL 1.2)	7年前
README.md	Added a note in the README about board specs	7年前
fp-lib-table	Added PD-Buddy v0.1 PCB	7年前
microcontroller.sch	No paste on P2 or SW1	7年前
output.sch	SMD flyback diode, 0.5 mm shorter PCB	7年前
pd-buddy-cache.lib	Rename board to PD Buddy Sink	7年前
pd-buddy.csv	Added PD-Buddy v0.1 PCB	7年前
pd-buddy.dcm	Corrected BJT connections	7年前
pd-buddy.kicad_pcb	Moved SW1 slider over board	7年前
pd-buddy.lib	Corrected BJT connections	7年前
pd-buddy.pro	Added PD-Buddy v0.1 PCB	7年前
pd-buddy.sch	Rename board to PD Buddy Sink	7年前
pd_phy.sch	Rename board to PD Buddy Sink	7年前
usb_type-c.sch	Rename board to PD Buddy Sink	7年前
voltage_regulator.sch	Rename board to PD Buddy Sink	7年前

PD Buddy Sink

This is the circuit board for the PD Buddy Sink, a device which aims to make USB Power Delivery accessible to any electronics hobbyist.

The board is designed for 2 oz copper. It’s probably best to use a 1.0 or 0.8 mm thick PCB to make sure it’s possible to solder the USB connector’s pins.

The PCB is made with KiCad, so you’ll need that if you want to make any changes.

README.md

PD Buddy Sink