6 anni fa 7 commits da master da questo rilascio
The first PCB release considered stable! Very similar to v0.3, this release is optimized for lower cost while retaining all functionality of the previous release.
Due to the last point, the programming jig did not require any changes in this release.
6 anni fa 25 commits da master da questo rilascio
A PD Buddy Sink designed for automated assembly!
Additionally, a programming jig has been designed to accommodate programming the Sink without a boot switch or programming header installed. The PCB can be found in the programming-jig
directory, and a 3D-printed spacer can be found in the pd-buddy-openscad repository.
7 anni fa 54 commits da master da questo rilascio
Finally, a hand-solderable Sink that doesn’t need rework! The output circuit has been fixed, so no cutting traces and point-to-point wiring should be necessary.
Other changes:
All the schematic changes have already been tested, so v0.2 should be ready for use. However, this is considered a pre-release because it isn’t really meant to be sent to a PCBA house yet.
7 anni fa 81 commits da master da questo rilascio
Initial prototype of PD Buddy. There are some pretty serious bugs here, so please don’t spend money to bring more of this version into the world. You’d be much better off using a newer version if you want to make a PD Buddy Sink.