Firmware for the remote control translator

Clara Hobbs 9b02a5011b Don't give up on transmitting the code Before, we'd give up on transmitting the RC5 power signal if a different NEC signal was received. This resulted in some cases where the green LED would get stuck on with no code being transmitted. Now that doesn't happen anymore because we just wait until no more NEC codes are received, then send the RC5 power signal. That is, the power signal only needs to be seen once, then once the channel is clear we transmit.		7年前
ChibiOS @ 3022045071	Added ChibiOS submodule	7年前
src	Don't give up on transmitting the code	7年前
.gitignore	Added an LED blinking example	7年前
.gitmodules	Added ChibiOS submodule	7年前
LICENSE	Initial commit	7年前
Makefile	Added an LED blinking example	7年前
README.md	Added an LED blinking example	7年前
chconf.h	Send a stream of power off signals to the TV	7年前
halconf.h	Made a mostly-working remote control translator	7年前
mcuconf.h	Made a mostly-working remote control translator	7年前

remote-control-translator-firmware

Firmware for the remote control translator

Flashing

openocd -f interface/stlink-v2.cfg -f target/stm32f1x.cfg -c "adapter_khz 4000; program build/remote-control-translator-firmware.elf verify reset exit"

README.md

remote-control-translator-firmware

Flashing