Don't give up on transmitting the code
Before, we'd give up on transmitting the RC5 power signal if a different NEC signal was received. This resulted in some cases where the green LED would get stuck on with no code being transmitted. Now that doesn't happen anymore because we just wait until no more NEC codes are received, then send the RC5 power signal. That is, the power signal only needs to be seen once, then once the channel is clear we transmit.
|6 years ago|
|ChibiOS @ 3022045071||6 years ago|
|src||6 years ago|
|.gitignore||6 years ago|
|.gitmodules||6 years ago|
|LICENSE||6 years ago|
|Makefile||6 years ago|
|README.md||6 years ago|
|chconf.h||6 years ago|
|halconf.h||6 years ago|
|mcuconf.h||6 years ago|
Firmware for the remote control translator
openocd -f interface/stlink-v2.cfg -f target/stm32f1x.cfg -c "adapter_khz 4000; program build/remote-control-translator-firmware.elf verify reset exit"