Firmware for the remote control translator

Clara Hobbs 9b02a5011b Don't give up on transmitting the code Before, we'd give up on transmitting the RC5 power signal if a different NEC signal was received. This resulted in some cases where the green LED would get stuck on with no code being transmitted. Now that doesn't happen anymore because we just wait until no more NEC codes are received, then send the RC5 power signal. That is, the power signal only needs to be seen once, then once the channel is clear we transmit.		7 роки тому
ChibiOS @ 3022045071	Added ChibiOS submodule	7 роки тому
src	Don't give up on transmitting the code	7 роки тому
.gitignore	Added an LED blinking example	7 роки тому
.gitmodules	Added ChibiOS submodule	7 роки тому
LICENSE	Initial commit	7 роки тому
Makefile	Added an LED blinking example	7 роки тому
README.md	Added an LED blinking example	7 роки тому
chconf.h	Send a stream of power off signals to the TV	7 роки тому
halconf.h	Made a mostly-working remote control translator	7 роки тому
mcuconf.h	Made a mostly-working remote control translator	7 роки тому

remote-control-translator-firmware

Firmware for the remote control translator

Flashing

openocd -f interface/stlink-v2.cfg -f target/stm32f1x.cfg -c "adapter_khz 4000; program build/remote-control-translator-firmware.elf verify reset exit"

README.md

remote-control-translator-firmware

Flashing